Összes szerző
Sipka Gábor
az alábbi absztraktok szerzői között szerepel:
-
Magyar Melinda
Rate-limiting steps in the dark-to-light transition of photosystem II: Dependence on the temperature and the lipidic environment of the reaction center -
Aug 31 - csütörtök
10:45 – 11:00
Bioenergetika és fotobiofizika
E41
Rate-limiting steps in the dark-to-light transition of photosystem II: Dependence on the temperature and the lipidic environment of the reaction center
Melinda Magyar1, Gábor Sipka1, Parveen Akhtar1, Guangye Han2, Petar H. Lambrev1, Jian-Ren Shen2,3 and Győző Garab1,4
1Institute of Plant Biology, Biological Research Centre, Szeged, Hungary
2Photosynthesis Research Center, Key Laboratory of Photobiology, Institute of Botany, Chinese Academy of Sciences, Beijing, China
3Research Institute for Interdisciplinary Science and Graduate School of Natural Science and Technology, Okayama University, Okayama, Japan
4Faculty of Science, University of Ostrava, Ostrava, Czech Republic
Photosystem II (PSII) is the redox-active pigment–protein complex embedded in the thylakoid membrane (TM) that catalyzes the oxidation of water and the reduction of plastoquinone. We performed single-turnover saturating flash-induced (STSF) variable chlorophyll-a fluorescence transient measurements on PSII, and we have identified rate-limiting steps in the dark-to-light transition of PSII [1]. It was demonstrated in diuron-treated samples that the first STSF – generating the closed state (PSIIC) – induces only an F1(<Fm) fluorescence level, and additional excitations with sufficiently long Δτ waiting times between them are required to reach the maximum (Fm) level. We also revealed that the F1-to-Fm transition is linked to the gradual formation of the light-adapted charge-separated state, PSIIL, which possesses an increased stabilization of charges [2]. Recently, we studied the effects of different physicochemical environments of PSII on the half-rise time (Δτ1/2) and probed its presence during later steps (F2, F3 etc.) [3, 4]. In particular, we investigated the influence of the lipidic environment [3] and the temperature dependence of Δτ1/2 of PSII core complexes (CC) of Thermosynechococcus (T.) vulcanus and pea TMs [4]. We showed that (i) while non-native lipids has no effect, TM lipids shorten the Δτ1/2 of PSII CCs of T. vulcanus to that of TMs – uncovering the role of lipid matrix in the rate limiting steps; (ii) PSII CCs of T. vulcanus and spinach TMs exhibit very similar temperature dependences, with enhanced values at low temperatures; and (iii) the Δτ1/2 values in PSII CC are essentially independent at all temperatures on the number of the STSF-induced increments. These data suggest that the same physical mechanism is involved during the PSIIC-PSIILtransition.
References
[1] Magyar M et al. (2018) Sci Rep 8: 2755
[2] Sipka G et al. (2021) Plant Cell 33: 1286-1302.
[3] Magyar M et al. (2022) Photosynthetica 60: 147-156.
[4] Magyar M et al. (2022) IJMS 24: 94-104.
-
Steinbach Gábor
Anisotropy imaging using RCM -
Aug 29 - kedd
15:30 – 17:00
I. Poszterszekció
P26
Anisotropy imaging using RCM
Gábor Steinbach1,2, Dávid Nagy3, Gábor Sipka2,4 , Ábel Garab2 , Győző Garab2,4 and László Zimányi3
1 ELKH, Biological Research Centre, Szeged, C ellular Imaging Laboratory
2 Biofotonika R&D Ltd.
3 ELKH, Biological Research Centre, Szeged, Institute of Biophysics
4 ELKH, Biological Research Centre, Szeged, Institute of Plant Biology
Both the differential polarization attachments for LSMs and Re-scan Confocal Microscopy (RCM) facilitate revealing structures at the molecular level [1]. For subcellular structures, increasing the available resolution can be fundamental. The re-scan confocal microscopy (RCM) provides 4 times better signal to noise ratio (compared to conventional PMTs) using an sCMOS camera, moreover, due to the second scanner, the image resolution increases by the factor of 1.4, while the axial resolution is identical with the LSMs [2].
With additional polarization elements, the RCM enables the 2D and 3D microscopic mapping of the anisotropy of samples via measuring fluorescence-detected linear dichroism (FDLD). The usage of the liquid crystal modulator for the RCM and the high frequency modulation (photoelastic modulator – PEM) are synchronised with the imaging. The DP-LSMs and the pRCM (RCM equipped with polarization attachment) are suitable for obtaining unique structural information on the anisotropic molecular organization of biological samples and intelligent materials [3, 4] in 2D and 3D.
References
[1] Steinbach et al. (2019) European Biophysics Journal 48: 457-463., doi: 10.1007/s00249-019-01365-4
[2] De Luca GMR et al. (2017) Methods Appl Fluoresc 5:015002., doi: 10.1088/2050-6120/5/1/015002
[3] Simonović Radosavljević J et al. (2021) Int. J. Mol. Sci. 22: 7661, doi: 10.3390/ijms22147661
[4] Pleckaitis M et al. (2022) Nano Research, 15: 5527-5537., doi: 10.1007/s12274-021-4048-x